Fixtures and lines we put in
Most installation calls fall into a few categories.
Faucets, sinks and vanities
New supply lines and shutoffs, correct trap height and a leak test under load.
Toilets and bidet seats
A new wax or rubber seal, a level flange and a supply that matches the tank inlet.
Showers and tubs
Valve rough-in, drain connections and a pressure test before tile covers the plumbing.
New water and drain lines
Added bathrooms, laundry rooms or wet bars need supply, drain and vent that work together.
Hose bibs and appliances
Frost-resistant outdoor faucets, dishwasher and ice maker lines, and disposals.
Basement finishing
Rough-in for a basement bath, with a sewage ejector when the drain sits below the main line.
Permits and inspections in Midvale
Midvale City says new construction, additions, basement finishes and remodeling require a building permit and building inspections. Permits are submitted online through Midvale Building and Safety at City Hall, 7505 S Holden Street, and the office is open Monday through Thursday.
Whether a simple fixture swap needs one is a question for the city, so ask Midvale Building and Safety before you start. Inspection requests go in at least 24 hours ahead, and only the contractor on record can schedule them. For new lines in a finished basement, plan the permit into your timeline.
Which jobs can you do yourself?
Plenty of fixture work is fair game for a patient homeowner. Hidden lines and gas are not.
| Job | DIY realistic? | Why or why not |
|---|---|---|
| Swap a faucet | Yes, with basic tools | Watch for corroded shutoffs that break when turned |
| Replace a toilet | Often | Heavy lifting and a new seal. A rocking toilet may mean a bad flange |
| Replace a showerhead | Yes | Thread tape and a gentle hand |
| Move a sink or add a bath | Rarely | Drain slope, venting and permit rules apply |
| Hook up a gas appliance | No | A gas leak is dangerous. Leave it to licensed plumbers |
| Install an outdoor hose bib | Sometimes | Needs a hole through the wall and a freeze-resistant fitting |
If a repair is what you need rather than a new fixture, see toilet repair or faucet repair first. Sometimes a new fill valve costs far less than a new toilet.
Bought a fixture and need it installed?
Give us the model or the type. We will check that your existing lines can take it.
How an installation job runs
We keep it simple and clear, with no surprises at the end.
- 1
Describe the job
You tell us the fixture, the room and any plans for walls or floors.
- 2
Check the lines
We look at shutoffs, supply, drain size and venting before quoting.
- 3
Hear the price
You get a clear price before work starts, and any change is explained first.
- 4
Install and test
Everything is leak tested under pressure, and we run water for the final check.
Remodel plumbing: before the drywall or after
Timing matters more than most owners expect.
Plumbing after walls close
- Fewer routes for new pipe
- Open and patch drywall later
- Higher risk of damaging finished tile
- Harder to inspect hidden work
Plumbing before walls close
- Freedom to run supply, drain and vent
- Pressure test and inspection while open
- Rough-in set at the right height
- Lower patching costs
What Midvale's water means for new fixtures
Midvale City requires water-saving fixtures in new construction under the International Plumbing Code. If you are shopping for new faucets, showerheads or toilets, look for flow ratings on the box rather than assuming older numbers apply.
Some east-side homes use water purchased from Jordan Valley Water Conservancy District, and hard water can leave scale on fixtures faster. If aerators clog often, a water softener conversation may be worth having before you buy expensive finishes.
What affects the price of plumbing installation
Fixture price is only part of it. These costs show up often.
Insurance does not cover upgrades or remodels, though it may cover water damage if an installed fixture fails. Keep your receipts and photos of finished work.
Neighboring services
Working on an older house often turns up pipe problems, and we will tell you if a repiping discussion makes sense before you spend on new fixtures. If you are adding a heater as part of the project, see water heater installation for the permit and sizing questions.
Plumbing installation questions from Midvale homeowners
Midvale lists specific work that requires a permit, such as remodeling, basement finishes and water heater replacement. For anything else, ask Midvale Building and Safety at 801-567-7200 extension 1016.
Yes, in many cases. Bring the model name or send the specs so we can check that it fits your existing lines. If it is the wrong size or type for your space, we will say so.
A standard toilet swap usually takes an hour or two. Problems with the flange, shutoff or floor can add time, and we will explain before we continue.
Often, yes. The drain location matters. If the existing sewer line is above the floor, a sewage ejector pump may be needed. A permit is expected for basement finishes.
Do not force it. Old stops can snap and flood the room. Close the main shutoff to the house and call us to replace the valve.
We handle residential rough-in and finish plumbing for additions and remodels. For large new builds, talk to us about scope and timing first.